; newWindow.focus())
Real-Time 3D Graphics Simulation for Computer Numerical Control
| G75 GROOVING CYCLE | |
|
|
N_ G75 X_ Z_ F_ D_ I_ K_ |
| The G75 command invokes an outside diamter groove cycle. This cycle involves plunges into the workpiece from the outside of the workpiece parallel to the X axis. The X value is the final diameter. The Z value represents the final Z position. The F value specifies the incremental retract after every plunge. The I and K values specify the incremental movements in the X and Z axes, respectively. | |
| Example G75 | |
| % | (PROGRAM START FLAG) |
| :1075 | |
| N5 G90 G20 | |
| N10 T0505 F0.015 | |
| N15 M03 | |
| N20 G00 Z-0.5 M08 | |
| N25 X1.2 | |
| N30 G75 X0.5 Z-0.75 F0.125 D0 I0.125 K0.125 | |
| N35 G00 X4 | |
| N40 Z3 M09 | |
| N45 T0500 M05 | |
| N50 M30 |