; newWindow.focus())
Real-Time 3D Graphics Simulation for Computer Numerical Control
| G41 TOOL NOSE RADIUS (TNR) COMPENSATION LEFT | |
|
|
N_ G41 |
| The G41 command applies cutter compensation to the left hand side of the programmed tool path. This amount is equal to the current tool's nose radius value, which is stored in the Tool Offset Register table of the controller. This register number is referenced by the last two digits in the tool change command. For example, a tool change command with T0202 will reference the tool nose radius value in register #2. | |
| Example G41 | |
| % | (PROGRAM START FLAG) |
| :1041 | |
| N5 G20 G40 | |
| N10 T1212 M08 | |
| N15 G98 M03 S2000 | |
| N20 G00 X0 | |
| N25 Z0.1 | |
| N30 G01 Z-0.2 F2 | |
| N35 G00 Z3 | |
| N40 X4 T1200 | |
| N45 T1010 | |
| N50 G00 X0 | |
| N55 Z0.1 | |
| N60 G74 Z-2 F0.5 K0.25 | |
| N65 G00 Z3 | |
| N70 T1000 X4 | |
| N75 G99 T0808 | |
| N80 G41 G00 X0.8 | |
| N85 Z0.2 | |
| N90 G01 Z-1.75 F0.012 | |
| N95 X0.9 | |
| N100 Z-0.25 | |
| N105 G03 X2 Z0 R0.5 | |
| N110 G40 G00 X4 Z3 M09 | |
| N115 T0800 M05 | |
| N120 M02 |